Every test we run, grouped by system.
We test the systems a data center depends on, from ductwork and chilled water to switchgear, generators and suppression rooms. Book one test or several. Each is quoted on its own and ends with a signed report.
Mechanical
Air and water systems: ductwork, chillers, CRAH units, pumps and fans.
Duct leakage testing
How this test worksEach duct section pressurised and measured against its leakage class, before insulation and ceilings go in.
Testing, adjusting and balancing
How this test worksAirflow and water flow measured at every terminal, coil and pump, then set to the design flow rates.
Mechanical testing
How this test worksChillers, CRAH units, pumps and fans run at each load step and measured against their design duty.
- Chillers
- CRAH and CRAC units
- Air handling units
- Pumps
- Fans
- Duty and standby
- Safeties and alarms
Electrical
Power systems from the incoming supply to the rack: generators, UPS, switchgear and cabling.
Electrical testing
How this test worksInsulation, earthing, protection and load tests on switchgear, transformers, UPS systems and generators.
- Insulation resistance
- Earthing
- Circuit breakers
- Protection relays
- Transformers
- Generators and motors
- Power factor
- Harmonics
- Load flow studies
- Short circuit studies
Fire protection
Gas suppression rooms that have to hold their agent long enough to put out a fire.
Room integrity testing
How this test worksA door fan test that predicts whether clean agent or inert gas holds its concentration for the full hold time.
Need a test that isn't listed?
Send us the testing section of your specification. We'll tell you which tests we can run and reply with a test plan and a quote.